kVp Output Waveform Initial Rise 10-20 kVp High For 4-5 ms. (During Calibration And Applications), And Then Drops To Proper Selected kVp Value. NO System Error Codes Displayed During Applications Other Than Occasional “k | AMCI Medical Imaging

top of page

Troubleshooting AMX

Error Number

kVp Output Waveform Initial Rise 10-20 kVp High For 4-5 ms. (During Calibration And Applications), And Then Drops To Proper Selected kVp Value. NO System Error Codes Displayed During Applications Other Than Occasional “k

Error Code / System Message

Error Question

How do I troubleshoot this AMX-4 Series issue: kVp Output Waveform Initial Rise 10-20 kVp High For 4-5 ms. (During Calibration And Applications), And Then Drops To Proper Selected kVp Value. NO System Error Codes Displayed During Applications Other Than Occasional “k?

Short Answer

Replace bad Power Module SCR Q3 Block and/or Filament kVp Board

Possible Causes

Problem: kVp Output Waveform Initial Rise 10-20 kVp High For 4-5 ms. (During Calibration And Applications), And Then Drops To Proper Selected kVp Value. NO System Error Codes Displayed During Applications Other Than Occasional “kVp LIMITS” Error During Calibration.

Troubleshooting Steps

Replace bad Power Module SCR Q3 Block and/or Filament kVp Board

Parts Areas to Check

Filament kVp Board; Power Module SCR Q3

For Related Models

AMX-4, AMX-4+, Definium AMX 700

bottom of page