Boot stop after a board was replaced | AMCI Medical Imaging

top of page

Troubleshooting AMX

Error Number

Boot stop after a board was replaced

Error Code / System Message

Error Question

Why did my XR200amx or XR220amx boot stop after a board replacement?

Short Answer

The BDM checks component fingerprint and firmware data at power-up; a mismatch can halt boot until the correct recovery action is selected.

Possible Causes

New/replaced intelligent board does not match BDM fingerprint or firmware data.

Troubleshooting Steps

Identify the replaced part and use the manual's Restore/Cancel table for that component. If an incorrect choice was previously made, a Load from Cold may be required.

Parts Areas to Check

For Related Models

Optima XR200amx, Optima XR220amx

bottom of page