Detector connect to the AP but not get a proper IP address | AMCI Medical Imaging

top of page

Troubleshooting AMX

Error Number

Detector connect to the AP but not get a proper IP address

Error Code / System Message

Error Question

Why does an XR240amx detector connect to the AP but not get a proper IP address?

Short Answer

Use the AP client list to verify the detector is recognized and has an assigned IP address, then reboot the detector and system if needed.

Possible Causes

Unrecognized detector connection; failed IP assignment; AP pairing state issue.

Troubleshooting Steps

Run the AP clients diagnostic, confirm the detector is listed and has a proper IP, then reboot the detector and system. If AP power was lost, detectors may need to be paired again.

Parts Areas to Check

For Related Models

Optima XR240amx

bottom of page