AMX Troubleshooting & Technical Support
Results Count
Error Number
Power supply LED status Power input LED
Error Code System Message
Power Input - GREEN
Question
What does the Power Input LED mean on the Definium AMX 700 detector power supply?
Short Answer
AC/DC input available.
Possible Causes
AC/DC input available
Troubleshooting Steps
If off, verify AC/DC input to the detector power supply.
Parts Areas to Check
Detector Power Supply
For Related Models
Definium AMX 700
Error Number
Prep/expose problem
Error Code System Message
EXPOSR / X-RAY ON LEDs
Question
What should I check if the Definium AMX 700 will not prep or expose?
Short Answer
The Beetle functional test verifies an exposure, the audible tone and X-ray ON LEDs.
Possible Causes
Exposure inhibit; Beetle Board signal issue; generator/AMX exposure-circuit issue.
Troubleshooting Steps
Perform the approved Prep/Expose functional test. Verify the exposure tone and X-ray ON indicators. If the EXPOSR LED is lit, investigate the exposure-inhibit condition first.
Parts Areas to Check
Beetle Board; AMX exposure control; generator
For Related Models
Definium AMX 700
Error Number
Red ON with BIST fail pattern
Error Code System Message
Red ON with BIST fail pattern - Built In Self Test failure
Question
What does “Red ON with BIST fail pattern” mean on a GE Definium AMX 700?
Short Answer
Red ON with BIST fail pattern: Built In Self Test failure.
Possible Causes
Subsystem/category: Digital Detector. Source classification: LED STATUS.
Troubleshooting Steps
Do not continue normal use; investigate the detector and escalate.
Parts Areas to Check
TRAD digital detector
For Related Models
Definium AMX 700
Error Number
Risk of CMOS corruption
Error Code System Message
Question
Can I turn off the Definium AMX 700 PC while saving BIOS changes?
Short Answer
No. The manual warns not to power off the computer while ROM is saving F2 changes because the CMOS could become corrupted.
Possible Causes
Power interruption while BIOS changes are being written.
Troubleshooting Steps
Wait until BIOS Save and Exit has completed before removing power. If settings are no longer correct afterward, restore the GE-specific setup values.
Parts Areas to Check
Magic PC CMOS/BIOS
For Related Models
Definium AMX 700
Error Number
SB_NORMAL
Error Code System Message
SB_NORMAL - Normal mode after BIST pass
Question
What does “SB_NORMAL” mean on a GE Definium AMX 700?
Short Answer
SB_NORMAL: Normal mode after BIST pass.
Possible Causes
Subsystem/category: Beetle Board. Source classification: LED STATUS.
Troubleshooting Steps
Interpret the LED together with the system symptom and use the matching Beetle/power/exposure troubleshooting path.
Parts Areas to Check
Beetle Interface Board