AMX Troubleshooting & Technical Support
Results Count
Error Number
Generator rotation issues
Error Code System Message
Question
What does the Brivo XR285amx generator Rotation Test check?
Short Answer
It combines tube rotor impedance, 70C thermal-circuit checks, rotation-board communication, sequence start/brake, discharge, and checksum verification.
Possible Causes
Rotor board; stator/tube; thermal circuit; communication or rotation sequence fault.
Troubleshooting Steps
Run Rotation Test. If it fails, use the rotor-specific error code and rotor communication data to isolate power, CAN communication, stator wiring, or rotor-board problems.
Parts Areas to Check
For Related Models
Brivo XR285amx
Error Number
Hand switch not working
Error Code System Message
Question
How do I test the Brivo XR285amx wired hand switch?
Short Answer
The Wired Hand Switch diagnostic tests the X-ray generation initiation circuitry.
Possible Causes
Hand-switch or initiation-circuit fault.
Troubleshooting Steps
Run Wired Hand Switch in SUIF and follow the on-screen test. If it fails, isolate the hand switch, cable, and system-control initiation path.
Parts Areas to Check
For Related Models
Brivo XR285amx
Error Number
Indicators not lighting up
Error Code System Message
Question
How can I test the Brivo XR285amx X-ray indicators?
Short Answer
Use Overlay Test for a visual check and Audio Check for the audible X-ray-on indication.
Possible Causes
Overlay/display issue; audio/sonalert issue; system-control fault.
Troubleshooting Steps
Run Overlay Test and Audio Check separately. If either fails, troubleshoot the corresponding display/audio path before generator troubleshooting.
Parts Areas to Check
For Related Models
Brivo XR285amx
Error Number
No 48 Volts power present
Error Code System Message
Question
How do I troubleshoot 48 V power on the Brivo XR285amx Djinn generator?
Short Answer
The manual specifies 48 VDC ±2.5 V at the Djinn 48 V input with the indicated test setup.
Possible Causes
LVLE2 output fault; Power Module overcurrent; cable/connection problem.
Troubleshooting Steps
Measure the 48 V supply at the Power Module. If out of specification, test LVLE2 with system diagnostics and determine whether the Power Module is pulling the supply down.
Parts Areas to Check
For Related Models
Brivo XR285amx
Error Number
No battery voltage Djinn generator
Error Code System Message
Question
What battery voltage should be present at the Brivo XR285amx Djinn generator input?
Short Answer
The manual specifies at least 144 VDC at the Main Auxiliary input and at the Power Module end of the DC-bus cable.
Possible Causes
Low battery voltage; breaker/cable/connection issue.
Troubleshooting Steps
With the system in the specified state, verify at least 144 VDC at Main Auxiliary XJ1 and again at Power Module J1. Inspect breakers, cable condition, and connection tightness if voltage is missing.
Parts Areas to Check